is there anybody who knows any acid that etch ito thin films?
have a good work

Views: 26


You need to be a member of The International NanoScience Community to add comments!

Join The International NanoScience Community

Full member
Comment by Nagaraja K K on October 20, 2010 at 7:45pm
Do you use sputtering for depositing ITO? or any transparent film

Full member
Comment by yavuznuri on November 28, 2009 at 5:40am
oxalic acid does it dude..

Full member
Comment by naresh on September 11, 2009 at 12:01pm
yaaa... i have etched the ITO with hydrochloric acid and iron chloride. i'm afriad, i don't have the photos of the sample. i would like to fabricate the OLED in next week. if i do this work in next week, then i will send the photos.

Full member
Comment by zeynep meric on September 10, 2009 at 2:53pm
thanks a lot.
did you try this before? ıf you tried can ı look at your sample's pictures ıf you taka any photo before and after etching?
thanks again

Full member
Comment by naresh on September 10, 2009 at 11:43am
atomic ratio

Full member
Comment by zeynep meric on September 7, 2009 at 9:57pm
you mean with 1:1 atomic ratio or molar?
thanks a lot

Full member
Comment by naresh on September 7, 2009 at 8:12pm
use the hydrochloric acid and iron chloride (1:1) mixer

Welcome - about us

Welcome! Nanopaprika was cooked up by Hungarian chemistry PhD student in 2007. The main idea was to create something more personal than the other nano networks already on the Internet. Community is open to everyone from post-doctorial researchers and professors to students everywhere.

There is only one important assumption: you have to be interested in nano!

Nanopaprika is always looking for new partners, if you have any idea, contact me at editor@nanopaprika.eu

Dr. András Paszternák, founder of Nanopaprika

Next partner events of TINC

We are Media Partner of:

© 2015   Created by András Paszternák, PhD (founder).   Powered by

Badges  |  Report an Issue  |  Terms of Service