Replies to This Discussion

Permalink Reply by Dr.Claudio Gutiérrez on June 3, 2012 at 7:10am

I have not experience on synthesis and manipulation of metallic colloids, but a simple separation process is the use of nonsolvent aliquots (normally alcohols, depending of your surfactant) on colloidal solution, accompanied of centrifugal treatments and using desiccator, May be, this paper can be useful.

http://www.nanoscalereslett.com/content/4/5/465

                               

• ▶ Reply

Permalink Reply by Naren on June 3, 2012 at 7:29am

Better go for centrifugation at high rpm and remove the supernatant and keep in the oven at around 50 degrees

• ▶ Reply

Permalink Reply by Asim Umer on June 4, 2012 at 6:01am

Thank you very much Sir.

• ▶ Reply

Permalink Reply by Asim Umer on June 4, 2012 at 6:02am

Thanks a lot ...

• ▶ Reply

Permalink Reply by Satyendra Kumar on June 4, 2012 at 11:44am

You can use microemulsion method for the synthesis of nanoparticles

• ▶ Reply

Permalink Reply by Asim Umer on June 4, 2012 at 5:00pm

Dear Kumar, I have

• ▶ Reply

Permalink Reply by MADAN IYENGAR on June 6, 2012 at 5:05pm

Asim are you looking at recovery of copper NP??

Cheers

Madan Iyengar

www.ozosciences.com

• ▶ Reply

Permalink Reply by Don Baer on June 6, 2012 at 5:13pm

Depending on your needs, you might find the following paper of some value: J. T. Nurmi et al. "Recovery of Iron/Iron Oxide Nanoparticles from Solution: Comparison of Methods and their Effects"  Journal of Nanoparticle Research 2011  13(5) 1937-1952.

• ▶ Reply

Permalink Reply by Dr. Vandna Luthra on June 6, 2012 at 6:14pm

You can use centrifuging at 5000-6000 rpm for 10-15 minutes. This

can be further dried at moderate temperature. Also it would be good to

use alcohols.

All the best.

 

• ▶ Reply

Permalink Reply by HALA ELHADI MOHD on June 6, 2012 at 9:56pm

I have not experience on the copper , but h hope good luck for you dear>>>> i have qesution for what you need copper NPS????????????

• ▶ Reply

Permalink Reply by TamilSelvi on June 7, 2012 at 4:36am

hello!

First u have to centrifuge your sample . you try the rpm range from 3000 to 10,000 rpm  depending up on your particle size. larger the particle size lower rpm is enough. Then you can see the copper nanoparticle at the bottom remove the filtrate. Further  the trace of the solvent is removed by vacuum. if u heat to remove water some times nanoparticle change it's morphology. 

• ▶ Reply

Permalink Reply by D. Geethalakshmi on June 7, 2012 at 5:51am

centrifuge it for many times to remove excess DI water and form as a slury.  then pour it on petridish and dry it in proper environmental condition which u need.

• ▶ Reply

▶ Reply to Discussion

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page